All you need to program your new keyfob is it's six digit serial number (ESN).
It's located on a sticker attached to back of the keyfob.

Note: DSC uses Hex digits in it's wireless device ESN designations. Hex digit entries work like this:

A = * 1
B = * 2
C = * 3
D = * 4
E = * 5
F = * 6


So, you press * to enter Hex mode, then use digits 1 -  6 to represent A - F, simple enough.  But here's the tricky part, after you press * to enter Hex mode the system stays in Hex mode until you press * again.

To enter a six digit ESN of 648FE8 my actual key presses would be:

6 4 8 * 6 5 * 8

Use the guide below to complete your installation.

Step 2 - Program Your Wireless Key

Section 804 is the wireless device programming section:

Press 804 to enter wireless programming


Slot 41 is the first of sixteen wireless key slots:

Press 41


You'll now enter the six digit ESN from the sticker on the back of your wireless key:

Enter the six digit ESN


Now exit programming programming by pressing the # key twice:

Press # #


That's it! You've now programmed your new DSC wireless key